This guide from Academy S’OLI ECO PRO is for licensed beauty professionals using manual sugaring technique. Set out clean gloves, single-use spatulas, a clean dispensing surface, pre-sugaring cleanser, powder and a thermometer suitable for checking the paste. We make our professional sugar pastes with 100% natural, non-GMO ingredients.
1. Check the firmness before adding heat
Use Ultra Soft at room temperature without warming. Soft also usually works straight from the jar. Try Medium with a fresh spatula first. If it scoops and molds easily, use it as it is. Gently warm Hard in a professional sugar-paste warmer with a timer before scooping it from the jar. Aim for a portion that folds with light pressure and keeps its shape when lifted.
2. Use a professional sugar-paste warmer only
If warming is needed, use only a professional warmer designed for sugar paste. Do not use a microwave, wax warmer or any other heating device. Follow the instructions for your jar and warmer. The display shows the device temperature, so check the paste itself before it touches the client’s skin.
If the working portion feels hot or unevenly warmed, allow it to cool and check again. Use a clean, single-use spatula to dispense paste and keep the test portion out of the supply jar.
3. Take a clean portion from the jar
Wash and dry your hands. With clean gloves on and the jar steady on a clean surface, slide a fresh single-use spatula along the inside wall. Scoop a small portion up the side, then turn the spatula to gather the strand. Place the portion on a clean single-client dispensing surface or transfer it to a clean gloved hand. Close the jar. Start small while learning. Use a new spatula for every trip back to the jar. Discard paste that has touched skin, a used glove or the treatment surface.
4. Cleanse, dry and lightly powder
Inspect the area first. Work on intact skin and defer treatment on irritated, broken, sunburned or recently peeled skin. Cleanse away surface oil, lotion and deodorant with a pre-sugaring cleanser suitable for the area. Use a clean disposable wipe, follow the cleanser directions and let the skin dry fully.
Dispense a little cosmetic talc or mineral powder onto a clean pad away from the client’s face. Smooth a barely visible layer over the treatment area and remove the excess. Keep powder away from eyes, airways and mucous membranes. If perspiration returns, blot the moisture first and reapply a thin layer only where needed.
5. Mold against growth and remove with growth
Look at the direction the hairs lie. Support the skin with your free hand, set the portion down and slowly mold it against hair growth with your gloved fingertips. Make two or three controlled molding passes if needed. Keep the first section short, especially on the underarm, bikini area or face.
Hold the skin taut. At the end of the section, flick the paste in the direction of growth, keeping your hand close and parallel to the skin. Avoid lifting upward. Recheck the hair direction before the next section. If the paste sticks, support the skin and dissolve it with lukewarm water rather than pulling repeatedly.
6. Finish the service
Remove any sugar residue with water on a clean pad, pat dry and use an appropriate aftercare product according to its label. Discard the client’s portion, gloves and single-use tools. Clean the workstation before the next service.
Compare the four firmness levels or explore Academy S’OLI ECO PRO training.